NEW TO UNEARTHED UK

The ultimate lightweight carbon fibre stem for the Minelab Equinox metal detector. The unique design offers the very best in quality and style to enhance your experience with the Minelab Equinox.

Lower stem with iso-tip
The two part construction is both strong and light while being easily adjustable. It has all the holes for adjusting the arm cup and total length from the original three piece shaft but will fold much shorter while fully assembled by retracting the lower stem almost fully into the upper.

Adjustments to the lower stem is made simple by our own quick release, lever cam-lock made from tough light nylon and a no-nonsense one-piece stainless steel button clip. The cam-lock has been specially designed to be compatible with standard Minelab spare parts. In the event of wear the lever, pivot pin and press block may be replaced with those from the Minelab E-Trac and Safari cam-locks, giving you peace of mind that spares are available from Minelab outlets.

ENHANCED DESIGN
A slight change to the upper shaft specification allows the lower to slide more freely inside it. The lower shaft has shed a little weight since the first batch bringing it down to just 70 grams. We have also redesigned the iso-tip which holds the coil, now held in place with a flexible aerospace grade epoxy resin. A further enhancement is the addition of drain holes in the tip to allow water to run out freely after detecting in water.

Equinox Carbon Shaft with the 15 Inch Coil
The Equinox Carbon Shaft with the 15 Inch Coil
Our prototype design has been field tested with the 15″ coil (EQX15) to ensure the cam-lock and button clip gives a firm hold free from any wobble.

In addition to this full shaft we can supply just the upper or the lower shaft separately.

Both parts are compatible and interchangeable with the standard Minelab Equinox shafts allowing you to swap and change parts at your convenience, for example a spare lower may be used to hold an accessory coil for quick change over.

CMD Quick release cam-lockCMD Quick release cam-lock
CMD’s Quick Release Cam-Lock
MATERIALS
Upper and Lower Shaft
Carbon Fibre, for maximum strength at minimum weight.
Cam-Lock and Iso-Tip
Nylon, tough, durable and light.
Button Clip and Cam-Lock Pivot
Stainless Steel, avoids corrosion in salt water use.
SPECIFICATION
Upper Shaft Length
880mm
Upper Shaft Weight
106g
Lower Shaft Length
615mm
Lower Shaft Weight
70g
Total Length Retracted
965mm
Max Length Extended
1378mm
Min Length Extended
1098mm
Total Weight
176g

Minelab Equinox Coil cover, suitable for the Equinox 600 & 800.

NEW TO UNEARTHED UK

Minelab Equinox Lower Stem

A Genuine Minelab spare part, lower stem for the Equinox. For use as a replacement or spare for accessory coils, Now in Stock,

SUITABLE FOR THE FOLLOWING:

• Equinox 800
• Equinox 60